For 1/4" diameter rivets AN430 rivets. Double offset rivet set, 7" long. Fits .401" bore rivet guns.

Unibit #3 Step Drill Bit, 9 Hole Sizes, 1/4 to 3/4 in, 1/16 in Steps, High-Speed Steel, Hex Shank.

EXL unitized wheels are great for edge deburring, blending, and finishing. They leave a very high luster satin finish that’s ready for painting or fine polishing. 3" Diameter, A COARSE grade.

This kit will adapt the FMC-2000 series Oil Filter Cutter to work with Kelly Aerospace oil filters. The complete retrofit takes less than 5 minutes to complete, and requires no additional tooling.

Replacement wire pack for CT450

#1 Phillips Screwdriver Bit Fits into any tool with a 1/4x28 threaded drive.

Edge Finders are essential when you need to precisely find the edge of a piece before milling. Standard .500" diameter , accurate to .0005".

Dual Edge Finder combines the two most common sizes (.500" and .200") into one tool. Use it to accurately locate the edges of work pieces before milling or drilling. Dual diameter .200" & .500" , accurate to .0005".

Pulls 3/16" countersunk or universal head Cherrylock rivets. The H681 series pulling heads are used to install 2000 series Cherrylock rivets. A separate pulling head is required for each diameter of rivet.

1/8" hex. Use these drivers to keep Hi-Lok fasteners when installing with hand wrenches. Hex tip can be replaced as needed. Comes complete with tip and installation wrench.

3/32" hex. Use these drivers to keep Hi-Lok fasteners when installing with hand wrenches. Hex tip can be replaced as needed. Comes complete with tip and installation wrench.

For 1/4" diameter rivets AN430 rivets. Straight rivet set, 3" long. Fits .498" bore rivet guns.